1. Introduction #
The manufacturer innovateIT Car Wash Equipment LLC is committed to the continuous improvement of its equipment construction quality and the safe operation of its equipment.
1.1 Warranty #
This manual covers the installation, intended use, and maintenance of the dispenseIT Chemical Delivery System. Misuse or improper operation of this device will void the manufacturerโs warranty.
The dispenseIT is covered by a 1-year limited warranty from the date of shipment. This warranty shall be void and of no effect if:
- Any installation defect that was apparent or ascertainable at the time of installation was completed but was not promptly reported to innovateIT Car Wash Equipment LLC.
- Damage occurs due to the customerโs failure to observe any instructions from innovateIT Car Wash Equipment or an authorized distributor and/or requirements of the manufacturer with respect to the product.
- The breach results from misuse of the equipment as outlined in the instruction manual.
When purchasing through a distributor, please ask about their warranty coverage on the unit.
1.2 Safety Information #
The instructions in this manual provide you with the information necessary to install and operate the dispenseIT. Before starting installation, the instruction manual should be carefully read and understood. This relates to all dispenseIT documents from innovateIT Car Wash Equipment.
The basic prerequisite for safe working is compliance with all the safety and handling instructions stated in this manual. Furthermore, follow all local accident, hazard prevention regulations, or general safety regulations when installing and operating the dispenseIT.
The equipmentโs operation, maintenance, and troubleshooting must only be carried out by trained personnel. Personnel should be able to interpret a wiring diagram, use a multimeter to read AC and DC power, and apply Lock Out Tag Out (LOTO) safety procedures specific to the equipment.
Electrical installation must adhere to local codes and the National Electrical Code, ANSI/NFPA 70 for electrical wiring. To avoid electrical shock hazards, do not operate this device when controller enclosures are open and energized. Electrical power must be shut off and a lock-out procedure utilized to ensure all electrical power is disabled before performing maintenance to any portion of the system.
Plumbing installation must adhere to local code and Uniform Plumbing Code (UPC), and plumbing connections and drains must adhere to local standards and facility codes.
Do not remove any Caution, Warning, or any other descriptive labels from the dispenseIT. Do not operate this device in an explosive environment or in the presence of flammable materials.
Movement or vibrations during shipment may cause connections to loosen. Check all connections before starting up a unit.
This unitโs electrical enclosure is intended for installation in ordinary locations, by the National Electrical Code, ANSI/NFPA 70, where the ambient temperature does not exceed 104ยฐF maximum.
innovateIT Car Wash Equipment LLC does not accept liability for accidents or damages due to negligence or disregard for the instructions in this manual. Also, the Company does not accept liability for damages due to improper use of the equipment.
This instruction manual should always be kept in a safe and easily accessible place near the equipmentโs site of installation and operation, and be available for the operator at the user site at any time.
If the manual is damaged, lost, or misplaced, you should immediately request a new copy from innovateIT Car Wash Equipment LLC.
1.2.1 Notifications & Symbols #
- DANGER: Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
- WARNING: Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
- CAUTION: Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
- NOTE: Used to address practices not related to physical injury.