rinseIT Manual – Installation

Table of Contents

Lay the 8’ tall legs and the 12’ cross bar on the floor
- Lay one leg on the driver’s side of the conveyor and one leg on the passenger’s side of the conveyor
- Lay the cross bar perpendicular to the conveyor
Install the hardware (fig. 1.1-1.2)
- Insert (2) ½” x 4” SS u-bolts in the holes on top of the legs
- Install ½” flat washers on bolts
- Install ½” split lock washers on bolts
- Install ½” nuts on bolts
- Apply antiseize lubricant on all threads

Slide the cross bar under the u-bolts on both legs
Tighten the u-bolts to snug
Stand the arch up with the help from of an equipment lift
Once your are satisfied with the placement of the arch, anchor the arch to the concrete floor
Anchors should be a minimum of ½”-4.50”. Stainless steel is recommended
Verify that the legs are square and plumb using a 4’ level
Tighten all remaining hardware

Apply antiseize lubricant to all threads
Place the drive linkage between the oscillate flywheel that is mounted to the gearbox and the oscillate pitman arm that is mounted to the manifold assembly (fig. 2.1)
Install the 3/8” shoulder bolt through the spherical rod end
Install a 3/8” flat washer
Install a 3/8” nut as a jam nut
Thread the shoulder bolt into flywheel/pitman arm the whole way (fig. 2.2)
While holding the shoulder bolt with allen wrench, use a 9/16” wrench and tighten the 3/8” nut
Apply antiseize lubricant on all threads

The amount of oscillation (throw) of each manifold can be adjusted in two ways:
- Adjusting the shoulder bolt location in the driveshaft plate (fig 4.1)
- Adjusting the shoulder bolt locations on the manifold’s pitman arm (fig. 4.2)

Install the stainless steel mounts for the high pressure stainless steel tubing
- When making hose connections it is best to keep the mounts on the vertical legs as close as possible to the connection points of the tubing for stability
- Evenly space the mounts across the top evenly
- Apply antiseize lubricant to all threads
Connect the high-pressure hose from the backroom pump to the stainless steel tubing
Connect the provided high-pressure hose from the stainless steel tubing to the manifold on both the driver and passenger sides

WARNING! To be performed by qualified electrician